Our new article in Cal Lab Magazine covers a lot of ground about what your can, and can’t, expect from your roughness or roundness gage. Knowing the strengths and limitations can help you avoid errors and misinterpretations, and expensive mistakes on the shop floor.
From handheld roughness gages to high-end interferometers, there’s a vast array of instruments available to measure roughness and roundness. But not all instruments are equal. Knowing the strengths and limitations of your gage can help avoid measurement errors that lead to expensive mistakes on the shop floor. Measurement instrument manufacturers offer systems with many different…
The term “included angle” can be confusing as it’s come to have two meanings for diamond stylus tips. Included angle = Included flank angle = cone angle In the ASME B46.1 standard, “included angle” is used as a synonym for “included flank angle,” the angle formed by the two sides of the diamond tip. It’s…
Replacing a metrology system can be a huge expense, so keeping older gages in service is vital for many businesses. Older systems need support to keep going, but even instruments with a lot of wear and tear can continue to perform reliably. So, how bad can a system get, but still be useable? It just…
